Tail Hoop - 1 inch or 7/8 inch - Straight or Upswept - Raw - Large CC Bikes

Manufactured right here in Dime City out of cold rolled .095 wall DOM steel tubing - we put the bricks to the bender and kick out these super sweet tails just for you. We leave an extra 7 inches on each side so you can cut it to match the length of your seat for that perfect custom look right in your garage!

As a standard we offer them completely straight out and flat - but for those looking for a little more racey look - we put a slight bend right before the main radius creating a nice upward slope and a more modern and progressive stance.

Typically - the smaller one (this one) is good for most 350cc to 500cc bikes and the larger loop is good for just about anything over 500cc.

Installation is simple - just cut off the back half of your frame (at your own risk) - chamfer the edges of the frame and the tube - get a buddy to hold it in place and weld away. Just smooth out the welds with a flap wheel and grinder and paint or powder coat it to your liking!

And remember, if your frame is slightly wider or skinnier - don't fret. Get the one closest and with some patience - a little heat and some additional welding and cutting you can most likely get a perfect fit!

Installation Notes: Depending upon where you cut your frame and where you cut the tail upon receipt you may need to open or close the gap a bit. This can be done easily by putting one end of the tail in a vice, locking it down - and using a longer piece of steel to pull - or open the gap. In the same respect you can close the gap by simply putting a ratchet strap around the ends tightening it in order to get the fitment spot on with your frame.